 |
1A Plain Installation
Plain wall letters are shipped without mounting hardware. |
 |
1B Flange Installation
Flange is a flat, 3/16" to 1/2" perimeter on the letter return of a formed wall letter into which holes can be drilled. Secure this type of wall latter with screws or nails. A wider flange is availabe upon request. Flange is not recommended for wall letters under 6" tall. |
 |
2A Stud Installation
Studs are metal threaded posts on the rear of the letters. Please specify if studs need to be in line for brick or block wall mortar joints. Stud mount orders include studs long enough to stand off approximately one and a half to two inches from the back of the wall letters. (Brick: 2 5/8" on center; Block: 8" on center). |
| |
 |
2B Pad Installation
Pads are plastic disks on the rear of the wall letters. Secure the letters to the wall using a spacing tape guide and silicone adhesive. Adjustable or flush pads are available upon request. Pad mount is only recommended on wall letters less than 24" tall.
|
|
|
 |
2C Combination Mount
This combination has pads at the bottom of the wall letter and pad/stud combinations at the top of the letter. Please specify if studs need to be in line for brick or block wall mortar joints. Not intended for letters under 6" tall.
Follow instructions 1-6 of stud mount method for top studs and silicone bottom pads. |
 |
2D Combination All Mount
With this combination, all wall letters have stud-through-pads on all mounts. Please specify if studs need to be in line for brick or block wall mortar joints. Not intended for letters under 6" tall.
Follow instructions for stud mount. Apply extra silicone on stud-through-pad in step #6 to adhere pad to mounting surface. Always clean surface before using silicone. |
| |